Pass Cisco 300-730 Exam With Practice Test Questions Dumps Bundle
2021 Valid 300-730 test answers & Cisco Exam PDF
Certification Path to Develop Your Skills Further
After earning the CCNP Security professional-level designation, the best course of action would be going for the CCIE Security. This is an expert-level certification that is considered one of the most prestigious validations worldwide in the field of technology. However, it is not recommended to go for the CCIE straight after earning the CCNP Security. A few years of experience in the field would help you earn the CCIE Security certification much easier and faster. In all, such a certificate will equip you with the relevant knowledge to provide advanced-level security solutions with the help of security technologies endorsed by Cisco.
NEW QUESTION 26
In a FlexVPN deployment, the spokes successfully connect to the hub, but spoke-to-spoke tunnels do not form. Which troubleshooting step solves the issue?
- A. Verify the spoke configuration to check if the NHRP redirect is enabled.
- B. Verify that the tunnel interface is contained within a VRF.
- C. Verify that the spoke receives redirect messages and sends resolution requests.
- D. Verify the hub configuration to check if the NHRP shortcut is enabled.
Answer: C
NEW QUESTION 27 
Refer to the exhibit. The IKEv2 site-to-site VPN tunnel between two routers is down. Based on the debug output, which type of mismatch is the problem?
- A. peer identity
- B. transform set
- C. preshared key
- D. ikev2 proposal
Answer: A
Explanation:
Section: Troubleshooting using ASDM and CLI
NEW QUESTION 28
Which configuration construct must be used in a FlexVPN tunnel?
- A. multipoint GRE tunnel interface
- B. IKEv2 profile
- C. IKEv1 policy
- D. EAP configuration
Answer: B
NEW QUESTION 29
Refer to the exhibit.
Which type of mismatch is causing the problem with the IPsec VPN tunnel?
- A. crypto access list
- B. transform set
- C. preshared key
- D. Phase 1 policy
Answer: C
NEW QUESTION 30 
Refer to the exhibit. An SSL client is connecting to an ASA headend. The session fails with the message
"Connection attempt has timed out. Please verify Internet connectivity." Based on how the packet is processed, which phase is causing the failure?
- A. phase 4: ACCESS-LIST
- B. phase 5: NAT
- C. phase 9: rpf-check
- D. phase 3: UN-NAT
Answer: D
Explanation:
Section: Troubleshooting using ASDM and CLI
NEW QUESTION 31 
Refer to the exhibit. A customer cannot establish an IKEv2 site-to-site VPN tunnel between two Cisco ASA devices. Based on the syslog message, which action brings up the VPN tunnel?
- A. Reduce the maximum SA limit on the local Cisco ASA.
- B. Increase the maximum in-negotiation SA limit on the local Cisco ASA.
- C. Correct the crypto access list on both Cisco ASA devices.
- D. Remove the maximum SA limit on the remote Cisco ASA.
Answer: B
Explanation:
Section: Site-to-site Virtual Private Networks on Routers and Firewalls
NEW QUESTION 32
Refer to the exhibit.
What is configured as a result of this command set?
- A. FlexVPN client profile for IPv6
- B. FlexVPN server to authenticate IPv6 peers by using EAP
- C. FlexVPN server to authorize groups by using an IPv6 external AAA
- D. FlexVPN server for an IPv6 dVTI session
Answer: A
Explanation:
Reference:
https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/sec_conn_ike2vpn/configuration/xe-3s/sec-flex- vpn-xe-3s-book/sec-cfg-flex-clnt.html
NEW QUESTION 33
Which command shows the smart default configuration for an IPsec profile?
- A. ipsec profile does not have any smart default configuration
- B. show run all crypto ipsec profile
- C. show crypto ipsec profile default
- D. show smart-defaults ipsec profile
Answer: C
NEW QUESTION 34
Which two types of web resources or protocols are enabled by default on the Cisco ASA Clientless SSL VPN portal? (Choose two.)
- A. VNC
- B. ICA (Citrix)
- C. HTTP
- D. RDP
- E. CIFS
Answer: D,E
NEW QUESTION 35
Refer to the exhibit.
A network engineer is reconfiguring clientless SSLVPN during a maintenance window, and after testing the new configuration, is unable to establish the connection. What must be done to remediate this problem?
- A. Enable clientless protocol under the group policy.
- B. Enable auto sign-on for the user's IP address.
- C. Enable DTLS under the group policy.
- D. Enable client services on the outside interface.
Answer: A
NEW QUESTION 36
What is a requirement for smart tunnels to function properly?
- A. Applications must be UDP.
- B. Java or ActiveX must be enabled on the client machine.
- C. Stateful failover must not be configured.
- D. The user on the client machine must have admin access.
Answer: B
NEW QUESTION 37
Which technology is used to send multicast traffic over a site-to-site VPN?
- A. IPsec tunnel on FTD
- B. GRE over IPsec on IOS router
- C. GRE over IPsec on FTD
- D. GRE tunnel on ASA
Answer: C
Explanation:
Section: Secure Communications Architectures
NEW QUESTION 38
Which redundancy protocol must be implemented for IPsec stateless failover to work?
- A. VRRP
- B. GLBP
- C. HSRP
- D. SSO
Answer: C
Explanation:
Reference:
https://www.cisco.com/c/en/us/support/docs/security-vpn/ipsec-negotiation-ike-protocols/17826- ipsec-feat.html
NEW QUESTION 39
A network engineer has been tasked with configuring SSL VPN to provide remote users with access to the corporate network. Traffic destined to the enterprise IP range should go through the tunnel, and all other traffic should go directly to the Internet. Which feature should be configured to achieve this?
- A. dual-homing
- B. hairpinning
- C. U-turning
- D. split-tunnel
Answer: D
NEW QUESTION 40
An engineer notices that while an employee is connected remotely, all traffic is being routed to the corporate network. Which split-tunnel policy allows a remote client to use their local provider for Internet access when working from home?
- A. excludeall
- B. tunnelspecified
- C. tunnelall
- D. excludespecified
Answer: B
NEW QUESTION 41
Refer to the exhibit.
An engineer is troubleshooting a new GRE over IPsec tunnel. The tunnel is established but the engineer cannot ping from spoke 1 to spoke 2. Which type of traffic is being blocked?
- A. ISAKMP packets from spoke1 to spoke2
- B. ESP packets from spoke2 to spoke1
- C. ISAKMP packets from spoke2 to spoke1
- D. ESP packets from spoke1 to spoke2
Answer: B
NEW QUESTION 42
Which feature allows the ASA to handle nonstandard applications and web resources so that they display correctly over a clientless SSL VPN connection?
- A. WebType ACL
- B. plug-ins
- C. single sign-on
- D. Smart Tunnel
Answer: D
Explanation:
Section: Remote access VPNs
Explanation/Reference: https://www.cisco.com/c/en/us/td/docs/security/asa/asa90/configuration/guide/ asa_90_cli_config/vpn_clientless_ssl.html#29951
NEW QUESTION 43
A network engineer must design a remote access solution to allow contractors to access internal servers. These contractors do not have permissions to install applications on their computers. Which VPN solution should be used in this design?
- A. Clientless
- B. IKEv2 AnyConnect
- C. Port forwarding
- D. SSL AnyConnect
Answer: A
NEW QUESTION 44
Refer to the exhibit.
The customer can establish a Cisco AnyConnect connection without using an XML profile. When the host "ikev2" is selected in the AnyConnect drop down, the connection fails. What is the cause of this issue?
- A. The HostName is incorrect.
- B. UserGroup must match connection profile.
- C. The IP address is incorrect.
- D. Primary protocol should be SSL.
Answer: B
NEW QUESTION 45
What are two purposes of the key server in Cisco IOS GETVPN? (Choose two.)
- A. to download encryption keys
- B. to encrypt data traffic
- C. to maintain encryption policies
- D. to authenticate group members
- E. to distribute routing information
Answer: C,D
NEW QUESTION 46 
Refer to the exhibit. Based on the exhibit, why are users unable to access CCNP Webserver bookmark?
- A. The bookmark has been disabled.
- B. The URL is being blocked by a WebACL.
- C. The ASA cannot resolve the URL.
- D. The user cannot access the URL.
Answer: A
Explanation:
Section: Remote access VPNs
NEW QUESTION 47
A second set of traffic selectors is negotiated between two peers using IKEv2. Which IKEv2 packet will contain details of the exchange?
- A. IKEv2 CREATE_CHILD_SA
- B. IKEv2 IKE_AUTH
- C. IKEv2 INFORMATIONAL
- D. IKEv2 IKE_SA_INIT
Answer: C
NEW QUESTION 48
......
Top Cisco 300-730 Courses Online: https://www.passleadervce.com/CCNP-Security/reliable-300-730-exam-learning-guide.html
Free Cisco 300-730 Exam Questions & Answer from Training Expert PassLeaderVCE: https://drive.google.com/open?id=1ESA85H47SsBRTGaH7GvKQPst8PI_iP0Y